Anamorphic Lens Installation (D-73D/Cinewide With Autoscope Only); Unlocking The Primary Lenses - Runco D-73d Ultra Installation & Operation Manual

Table 3-6. D-73d Optical Alignment Procedure (with Anamorphic Lenses) (continued)
Dimension Digital Controller
1. Select Aspect Ratio and set it to Cinema.
2. Select Calibration -> Image Alignment ->
Corner Alignment and adjust corners.
3. Select Calibration -> Image Alignment ->
Midpoint Alignment and adjust
midpoints.
If you are installing a D-73d/CineWide with AutoScope, install the anamorphic lenses
as described in the section entitled D-73d/CineWide or D-73d/CineWide with
AutoScope - Shasta Anamorphic Lens Installation on page 58. Ensure that the
AutoScope lens motor power switch is in the "off" position and the lenses are out of the
light path.
Insert the provided hex wrench into
the lens lock access hole at the
front of the projector. Then, turn
the wrench counterclockwise two
or three full turns to unlock the
lens. Do this for both primary
lenses.
Do not attempt any primary lens adjustments when the lenses
Caution
are locked. Doing so may cause damage to the zoom or lens
shift mechanisms.
D-73d Series Installation/Operation Manual
Projector
No adjustment needed.
END
Projection
Lens
Lens Lock
53
Note: The Dimension Digital Controller
saves the Image Alignment (warp) set-
tings for each aspect ratio. To program
additional aspect ratios, select each
one and use the controls in the Corner
Alignment and Midpoint Alignment
menus. Or, select
Calibration -> Copy/Paste -> Aspect
Ratio -> Copy Settings, select a differ-
ent aspect ratio and choose Paste
Settings.
Anamorphic Lens
Installation
(D-73d/CineWide with
AutoScope Only)
Unlocking the Primary
Lenses
Horizontal
Lens Shift
Vertical
Lens Shift
Installation