Whitney (Prismatic) Anamorphic Lens Installation And Adjustment; Prismatic Anamorphic Lens Mounting Assembly - Exploded View - Runco RS-1100 CineWide User Manual

The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-22.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
1 Anamorphic Lens
2 Base Plate
3 Screw, Phillips
M6x16mm (2x) and
1/4" Flat Washer (2x)
(not shown; secures Base Plate
to bottom of projector)
Figure 3-22. Prismatic Anamorphic Lens Mounting Assembly - Exploded View
1. Use the Pitch Adjustment Screws and Washers (item #6) to attach the Vertical
Mounting Brackets (item #5) to the Anamorphic Lens (item #1).
2. Place the lens with the brackets installed on top of (or under, if the projector is
inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the
brackets pass through the corresponding slots on the base plate.
3. Secure the lens assembly to the base plate with the Yaw/Z-Adjustment Knobs and
Washers (item #4).
To avoid clipping the corners of the image, position the anamorphic
Tip
lens as close as possible to the primary lens.
RS-900 and RS1100 Series Installation/Operation Manual
6 Pitch/Y-Adjustment
5 Vertical Mounting
4 Yaw/Z-Adjustment
Ceiling Mount
Bracket
45
Screw, Phillips
Pan Head, 4-40 x 3/8"
(4x) and Fender
Washer (4x)
Bracket (2x)
Knob (2x) and
Washer (2x)
Installation
Whitney (Prismatic)
Anamorphic Lens
Installation and
Adjustment