Quick Setup - Runco XtremeProjection X-450d Installation & Operation Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the X-400d/X-450d installation process. The sections
following this one provide detailed instructions.
Table 3-1. Installation Overview
Step
Choose a location for the projector
1
2 Install anamorphic lens mounting assembly (optional)
Mount the projector
3
Mount the Dimension Digital Controller
4
Connect the Dimension Digital Controller to the projector
5
Connect other external equipment to Dimension Digital Controller
(optional):
• Audio processor or secondary display device
• Control system interface (RS-232)
6
• 12-volt trigger-activated equipment (retractable screens or
screen masking)
• External IR repeater
• Network hub, router or gateway (Ethernet)
Connect signal sources to the Dimension Digital Controller
7
Connect the Active 3D Emitter to the Dimension Digital Controller
8
Connect system components to AC power
9
10 Apply power to the projector
Adjust primary lens: projected image size (zoom), position (shift)
11
and focus
For rear-screen and/or ceiling-mount installations, select the
12
proper picture orientation
Use Image Alignment controls to fine-tune image geometry
13
14 Install and adjust secondary anamorphic lens (optional)
Display calibration: adjust the following for each Dimension
Digital Controller input and display mode (resolution/frame
rate); save settings when finished:
• Aspect ratio
15
• Brightness
• Contrast
• Color temperature and white balance
Prepare Active 3D Glasses for use and test with 3D source mate-
16
rial
Procedure
• Color level
• Tint
• Input position
18 Runco X-400d/X-450d Installation/Operation Manual
For Details, Refer
to page...
19
26, 38
32
33
34
36
41
47
47
48
22, 49
49
50
52
64 through 83
98