Channel Selection; Programming A Memory Channel - Icom IC-A210 Instruction Manual

3
MEMORY OPERATION

■ Channel selection

The transceiver has 10 channels in regular memory and 200
channels in the group memory. There are 10 channels in
each of 20 groups (GRP01–GRP20).
q Push [RCL] to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
w Rotate [O-DIAL] to select the memory channel type.
• Select from regular memory channel or group memory channel.
e Rotate [DIAL] to select a desired memory channel
number.
Transferring the memory channel to the active fre-
quency is necessary if you want to operate on the
memory channel frequency.
Refer to "Transferring memory contents" (p. 12) for
details.
r Push [RCL] to change to standby frequency to the se-
lected memory channel frequency and exit the memory
mode.
NOTE:
Hold down [RCL] for 2 seconds to exit the mem-
ory mode without changing the previously set standby fre-
quency.
10
RX
MEMORY
122.00 127.00
5
CH01
■ Programming a memory
channel
To program the memory channels, follow the steps below.
q Rotate [DIAL] and [O-DIAL] to set a desired frequency
for the standby frequency.
w Push [RCL] to enter the memory mode.
• The channel number appears.
• The memory channel name also appears if it has been entered.
e Rotate [O-DIAL] to select a desired memory channel
type.
• Select regular memory channel or group memory channel.
r Push [MEM], and then rotate [O-DIAL] to select the "RE-
PLACE" menu.
• The memory channel number blinks.
t Rotate [DIAL] to select a memory channel to be pro-
grammed.
y Push [MEM], to program the frequency into the channel.
• "WRITE COMPLETED" appears on the display when the regu-
lar memory channel is programmed.
u Push [RCL] to exit the memory mode.