Basic Operation; Turning On The Transceiver; Channel Selection - Icom IC-F6020 Series Instruction Manual

■ Turning ON the transceiver

q Push [ ] to turn ON the transceiver.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• The keys as shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
0 1
NUMBER
5 6
e When the "PASSWORD" indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn OFF the transceiver and start over in this case.
2 3 4
7 8 9

BASIC OPERATION

■ Channel selection

Several types of channels can be selected. Methods may
differ depending on your system set up.
NON-ZONE TYPE:
Push [CH Up] or [CH Down] to select the desired operating
channel, in sequence, or, push one of [MR-CH 1] to [MR-CH 4]
keys to directly select a channel.
ZONE TYPE:
Push [Zone], then push [CH Up] or [CH Down] to select the
desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the transceiver, the transceiver automatically starts
scanning. Scanning stops when a call is received.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
7