Direct Frequency Setting Mode Operation; Dualwatch Operation - Icom IC-A210 Instruction Manual

2
BASIC OPERATION
■ Direct frequency setting
mode operation
The direct frequency setting mode operation is useful when
setting a desired frequency directly as the active frequency.
q Hold down [↔] for 2 seconds to enter the direct frequency
setting mode.
• Only the active frequency is displayed.
w Set an operating frequency.
• Refer to pages 5, 6 in details.
RX
e Push [RCL] or [↔] to exit the direct frequency setting
mode.
8
121.80

■ DualWatch operation

The DualWatch operation monitors the active frequency
at certain intervals even when receiving a signal on the
standby frequency. When a signal is received on the active
frequency, the radio switches to the active frequency and
stays on it until the signal disappears, irrespective of the
standby frequency status.
q Push [DUAL] to enter DualWatch operation.
• "DUAL" appears on the active frequency indicator.
• The active or standby frequency ' s "RX" blinks when receiving a
signal or opening the squelch.
RX DUAL
121.00
w Push [DUAL] again to exit DualWatch operation.
• "DUAL" disappears.
ATTENTION!
During DualWatch operation, the standby
frequency's audio may be interrupted at the monitoring in-
terval, but this is not a malfunction.
RX
129.40
5