Icom IC-A210 Instruction Manual page 31

D Beep Tone Level "BEEP"
Confirmation beep tones normally sound when storing mem-
ory, operating time-out-timer function, etc. These can be set
a desired beep level as you prefer.
• OFF (0) : The beep tone turns OFF.
• 001 to 100 : Setting the beep tone level from 1 to 100.
NOTE:
When using an external speaker, the beep tone
level when the squelch is closed is fixed and cannot be
changed in the MENU mode.
D Intercom Usable Setting "INCOM MODE"
Set the intercom using or not.
• ON : The intercom is usable.
• OFF : The intercom is unusable.
D Time-Out-Timer "TIME OUT"
To prevent accidental prolonged transmission, the trans-
ceiver has a time-out-timer function. This timer starts when a
transmission begins, and will cut off the transmission when
the time set in the timer elapses.
• 020 to 240 : Setting time-out-timer starting period from 20 sec-
onds to 240 seconds in 10 secons intervals.
D Frequency Step "FREQ. STEP"
Set the desired frequency step: 8.33 kHz or 25 kHz.
• 25kHz : Setting the frequency step to 25 kHz.
• 8.33kHz : Setting the frequency step to 8.33 kHz.
D Interlock "INTERLOCK"
When two transceivers are connected together, the interlock
function can prevent them from transmitting at the same
time.
• TX INHIBIT : Transmission is prevented.
• RX MUTE : Audio output is prevented.
• BOTH : Transmission and audio output are both prevented.
NOTE:
The interlock does not appear when the "TX/RX
INTERLOCK SW" is set to "DISABLE," by the CS-A210.
D Memory Clear "MEM CLEAR"
Set values in the CPU are cleared.
Hold down [MEM] for 2 seconds, the CPU is reset as follows.
• MENU : MENU mode items are reset.
• MEMORY : Stored memories are reset.
• ALL : All CPU data is reset.
5
MENU MODE
05
27