Programming The Memory/Call Channels - Icom IC-V82 Instruction Manual

■ Programming the memory/call channels

qPush [D•
] to select VFO mode, if necessary.
CLR
w Set the desired frequency.
eSet other information, such as tone, duplex, as desired.
rPush [A•
], then [C•
FUNC MR
• " X " and memory channel number blink.
MONI PWR
A
FUNC
A B C D
FUNC CALL MR CLR
1 2 3
TONE P.BEEP T.SCAN BANK C
MR
4 5 6 0
DUP SCAN SKIP OPT
7 8 9
PRIO SET H/M/L ENT
tPush [Y Y ] or [Z Z ] to select the desired memory channel.
• When programming the call channel, select "C."
• When [VOL] is assigned as tuning dial, rotate [VOL] to select
the memory channel. (pgs. 14, 63)
MONI PWR
A B C D
FUNC CALL MR CLR
1 2 3
TONE P.BEEP T.SCAN BANK
4 5 6 0
DUP SCAN SKIP OPT
7 8 9
PRIO SET H/M/L ENT
] momentarily.
MEMORY/CALL OPERATION
yPush [A•
], then push [C•
FUNC
are emitted) to program the information into the selected
memory channel and return to VFO.
PWR
MONI
A
FUNC
A B C D
FUNC CALL MR CLR
1 2 3
TONE P.BEEP T.SCAN BANK C
MR
4 5 6 0
DUP SCAN SKIP OPT
7 8 9
PRIO SET H/M/L ENT
• Continue to hold [C• ] down for 1 sec. after 3 beeps are emit-
MR
ted, to increment the displayed memory channel number.
6
] for 1 sec. (until 3 beeps
MR
PWR
MONI
A B C D
FUNC CALL MR CLR
1 2 3
TONE P.BEEP T.SCAN BANK
4 5 6 0
DUP SCAN SKIP OPT
7 8 9
PRIO SET H/M/L ENT
6
21