Restoring The Factory Default Configuration; Factory Default Configuration Settings - Qlogic 5800V Series User Manual

5–Managing Switches

Restoring the Factory Default Configuration

6. If you select the Configured Zoning or Full Restore option and the file
contains zone sets, a dialog box prompts you to activate one of those zone
sets. Click Yes, and then select a zone set from the drop-down list in the
Select Zoneset to be Activated dialog box.
7. Click OK and view the results in the top pane of the Restore dialog box.
Restoring the Factory Default Configuration
You can restore the switch and port configuration settings to the factory default
values. To restore the factory configuration on a switch, on the Switch menu, click
Restore Factory Defaults. The factory default switch configuration settings are
listed in
Restoring the switch to the factory default configuration does not restore the
account name and password settings. The most current port license remains in
effect. To restore user accounts, you must select the Reset User Accounts to
Default option in the maintenance menu. For information about maintenance
mode and the maintenance menu, see "Recovering a Switch" in the QLogic
5800V Series Fibre Channel Stackable Switch Installation Guide or the QLogic
5800V Series Stackable Fibre Channel Switch Command Line Interface Guide.
Symbolic Name
Administrative State
Domain ID
Domain ID Lock
In-band Management
Broadcast Support
Resource Allocation Time-
out (R_A_TOV)
I/O Stream Guard
Device Scan Enabled
Error Detect Timeout
(E_D_TOV)
SNMP Enabled
SNMP Proxy
5-78
Table 5-18.
Table 5-18. Factory Default Configuration Settings
Setting
Fibre Channel Switch
Online
1
False
True
Enable
10000 milliseconds
Auto
True
2000 milliseconds
True
True
Value
59266-01 B