Qlogic 5800V Series User Manual page 161

Table 5-7. Create IP Security Policy Dialog Box Fields (Continued)
Protocol
IcmpV6Type
Direction
Priority
Action
Protection Desired
ahRuleLevel
59266-01 B
Field
Protocol or application to which to apply IP security. Enter a key-
word for one of the following protocols or an integer (0-255):
 Internet Control Message Protocol for IP version 4 (ICMP)
 Internet Control Message Protocol for IP version 6 (ICMPv6)
 Internet Protocol, version 4 (IPv4)
 Transmission Control Protocol (TCP)
 User Datagram Protocol (UDP)
 Any protocol
 0—255
ICMP number (0–255) if the protocol is ICMPv6.
Direction of the data traffic to which to apply the policy:
In—data entering the destination
Out—data leaving the source
Controls the relative ordering of this policy within the SPD
Processing to apply to data traffic:
 Discard—unconditionally disallow all inbound or outbound
data traffic.
 None—allow all inbound or outbound data traffic without
encryption or decryption.
 Ipsec—apply IP security to inbound and outbound data traffic.
Type of IP security protection to apply:
 AH—authentication Header
 ESP—encapsulating Security Payload
 Both—apply both AH and ESP protection
Rule level to apply for AH protection:
 Default
 Use—use IPsec if corresponding SAD entry found, don't use
IPsec if corresponding SAD entry not found.
 Require—use IPsec if corresponding SAD entry found, don't
communicate at all if corresponding SAD entry not found.
5–Managing Switches
Configuring the Network
Description
5-37