Ip Configuration - Qlogic SANbox 5802V QuickTools Switch Management User Manual

4 – Managing Switches
Configuring a Switch

IP Configuration

The IP configuration identifies the switch on the Ethernet network and determines
which network discovery method to use.
parameters.
Parameter
Network
Discovery
IP Address
Subnet mask
Gateway
4-24
Table 4-5. IP Configuration Parameters
Choose one of the following methods by which to assign the IP
address:
Static — uses the IP configuration parameters entered in the
Switch Properties dialog.
BootP — acquires the IP configuration from a BootP server. If no
IP address is obtained, the switch reverts to the previously con-
figured IP address.
RARP (Reverse Address Resolution Protocol) — acquires the IP
address from a RARP server. A RARP request is broadcast with
up to three retries, each at 5 second intervals. If no IP address is
obtained, the switch reverts to the previously configured IP
address.
DHCP (Dynamic Host Configuration Protocol) — acquires the IP
configuration from a DHCP server. If no satisfactory lease is
obtained, the DHCP client attempts to use the previously config-
ured lease. If the previous lease cannot be used, no IP address
will be assigned to this switch in order to avoid an IP address
conflict.
Internet Protocol (IP) address for the Ethernet port. The default value
is 10.0.0.1.
Subnet mask address for the Ethernet port. The default value is
255.0.0.0.
IP gateway address. The default value is 10.0.0.254.
Table 4-5 describes the IP configuration
Description
S
59264-00 A