Qlogic SANbox 5802V QuickTools Switch Management User Manual page 67

A
User Name
Login Level
Super User
UserAuthentication
Enabled
Firmware Group
Firmware Version
Inactive Firmware Version
Pending Firmware Version
PROM/Flasher Version
Services Group
NTP Client Enabled
NTP Server Address
FDMI Enable
FDMI HBA Entry Limit
Embedded GUI Enabled
Inactivity Timeout
GUI Mgmt Enabled
Telnet Enabled
SSH Enabled
59264-00 A
Table 4-1. Switch Data Window Entries (Continued)
Entry
Account name
Authority level
Super user privileges enabled/disabled
Enforcement of account names and authority (always
True)
Active firmware version
This field does not apply to this switch
Firmware version that will be activated at the next reset
PROM firmware version
Enabled or disabled. Allows for switches to synchronize
their time to a centralized server.
The IP address of the centralized NTP server. Ethernet
connection to NTP server is required.
Fabric Device Management Interface status. If enabled,
device information can be obtained, managed, and saved
through the fabric using Name Service Management
Server functions. QuickTools will report all FDMI informa-
tion reported by the entry switch, if FDMI is enabled on the
entry switch.
Maximum number of HBAs that can be registered with a
switch.
QuickTools web applet status. Enables or disables the
web applet on the switch.
Number of minutes the switch waits before terminating an
idle command line interface session. Zero (0) disables the
time out threshold.
Web applet status. If disabled, the switch cannot be man-
aged using the web applet.
Telnet client status
Secure Shell status. If enabled, an encrypted data path is
provided for command line interface sessions.
4 – Managing Switches
Switch Data Window
Description
4-5