EUROCOM X8100 Service Manual page 40

Disassembly
Processor Installation Procedure
Figure 12
Processor 1. Insert the CPU
Installation
the release latch
2. Remove the sticker
3. Insert the heat sink
a. Insert the CPU.
b. Turn the release latch to-
4. Tighten the CPU heat sink screws
wards the lock symbol.
5. Replace the component bay cover and tighten the screws
c. Remove the sticker from
the heat sink and insert
a.
the heat sink.
d. Tighten the screws.
b.

A. CPU
D. Heat Sink
• 4 Screws
2 - 16 Removing and Installing the Processor
, pay careful attention to the pin alignment, it will fit only one way (DO NOT FORCE IT!), and turn
A
towards the lock symbol
B
(Figure 12c) from the heat sink.
C
as indicated in Figure 12c.
D
, , , &
1 2 3
c.
A
d.
B
(Figure 12b).
(Figure 12d).
4
(page 2 - 14).
C
C
D
1
4
3
2