Processor Installation Procedure - EUROCOM W880CU Service Manual

Disassembly

Processor Installation Procedure

Figure 18
Processor 1. Insert the CPU
Installation
FORCE IT!), and turn the release latch
2. Remove the sticker
3. Insert the heat sink unit
a. Insert the CPU.
b. Turn the release latch to-
4. Tighten the CPU heat sink screws in the order
wards the lock symbol.
18d).
c. Remove the sticker from
5. Replace the CPU fan, component bay cover and tighten the screws
the heat sink unit and in-
sert the heat sink.
a.
d. Tighten the screws.
b.

A. CPU
D. Heat Sink
• 4 Screws
2 - 22 Removing and Installing the Processor
, pay careful attention to the pin alignment
A
B
(Figure 18c) from the heat sink unit.
C
as indicated in
D
c.
C
A
C
B
(Figure 18a), it will fit only one way (DO NOT
towards the lock symbol (Figure
Figure 18c.
, , & (the order as indicated on the label and
1 2 3 4
(page 2 -
d.
D
Note:
Tighten the screws in the order 1-2-3-4
as indicated on the label.
18b).
Figure
17).
4
1
3
2