Cpu/Video Card Pre-Installation Procedure - EUROCOM W880CU Service Manual

CPU/Video Card Pre-Installation Procedure

Turn off the computer, and turn it over and remove the battery
1.
2. Insert the CPU , pay careful attention to the pin alignment
A
FORCE IT!), and turn the release latch
3. Remove the stickers (Figure
C
4. Insert the heat sink unit as indicated in
D
5. Tighten the CPU heat sink screws in the order
11d).
6. Remove the protective mylar
- as indicated below (Figure
6 10
a.
A
b.
B
(page 2 -
(Figure
towards the lock symbol
B
11c) from the CPU heat sink unit.
Figure 11c.
, , &
1 2 3 4
from the video card and make sure that the 5 thermal pads are still on points
5 E
11e).
c.
C
C
D
d.
4
1
3
2
5) and component cover
11a), it will fit only one way (DO NOT
(Figure 11b).
(the order as indicated on the label and
e.
E
5
6
7 8
9
Note:
Tighten the screws in the
order 1-2-3-4 as indicated
on the label.
CPU/Video Card Pre-Installation Procedure 2 - 15
Disassembly
Figure 11
CPU/Video Card Pre-
(page 2 - 10)
.
Installation
Procedure
a. Insert the CPU.
b. Turn the release latch to-
wards the lock symbol.
Figure
c. Remove the stickers from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.
e. Remove the protective
mylar from the video card
and make sure that the
thermal pads are still on
-
points 6 10

Reminder
During delivery,
following are not yet
assembled inside the
10
computer:
Video Card & CPU Heat
Sinks
VGA Card
CPU

A. CPU
D. CPU Heat Sink
E. Video Card
• 4 Screws
.
the