FARGO electronics L000286 User Manual page 80

RESTRICTED USE ONLY
Interpreting LED Lights (continued)
Power Card
LED
LED
On solid Flashing
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1)
Ink Cause / Solution
LED
Off Indicates you need to check the status of the Card
Cartridge and/or the card being used for the current
print job. This LED will flash when:

The Card Cartridge is improperly installed or
missing. Verify the Cartridge is properly installed.
push down on the top of the Cartridge to Ensure it
is fully seated in the Printer.

The Card Cartridge is out of cards. Replace the
Card Cartridge.

A card is unable to feed from the Card Cartridge.
Verify the Cartridge is properly installed. Push
down on the top of the Cartridge to Ensure it is
fully seated in the Printer.

A card is jammed specificwhere along the Card
Path. Clear the jam.

A non Fargo-certified Card Cartridge is installed.
Use only Fargo Certified Supplies.
In any of these situations, correct the condition and
press the Card button to continue printing.

If neither the Ink Cartridge nor the Card Cartridge
are installed, only the Card LED will flash at first.
When the Card Cartridge is installed, the Ink LED
will then flash until the Ink Cartridge is installed.
These two lights will not flash simultaneously.

If the Printer has a Magnetic Encoding Module
installed and you are attempting to encode
magnetic information onto a card while printing, a
flashing Card LED can also indicate an encoding
mis-verify or specific other type of encoding error.

If information is not encoded properly or encoded
onto a bad magnetic stripe, the Printer is unable to
verify the encoded data. When this happens, the
Printer will signal an error on the PC screen.
Follow the on-screen prompts to correct this error.
Fargo Electronics, Inc.
Continued on the next page
3-6