Download Print this page
FARGO electronics PERSONA C30 User Manual

FARGO electronics PERSONA C30 User Manual

Fargo electronic printer user manual
Hide thumbs Also See for PERSONA C30:

Advertisement

Quick Links

RESTRICTED USE ONLY

Section 6: Cleaning

The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there
are a few procedures you can perform on a regular basis or as needed to ensure the best
possible performance
Safety Messages (review carefully)
Symbol
Critical Instructions for Safety purposes
Danger:
Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the left).
Caution:
This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the left).
Persona C30 Card Printer User Guide (Rev. 2.2)
To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.
To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.
To prevent personal injury, make sure only qualified personnel
perform these procedures.
To prevent equipment or media damage, refer to the following
safety messages before performing an operation preceded by this
symbol.
To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in
or near the Circuit Board and Printhead Assemblies.
To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).
To prevent equipment or media damage, always remove the
Ribbon and Cards from the Printer before making any repairs,
unless otherwise specified.
To prevent equipment or media damage, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the Printer.
IDentiphoto Company, Ltd
1810 Joseph Lloyd Parkway
Willoughby, OH 44094
Fargo Electronics, Inc.
800-860-9111
sales@identiphoto.com
www.identiphoto.com
6-1

Advertisement

loading

Summary of Contents for FARGO electronics PERSONA C30

  • Page 1: Section 6: Cleaning

    RESTRICTED USE ONLY Section 6: Cleaning The Card Printer is built to require a minimum amount of maintenance. Nevertheless, there are a few procedures you can perform on a regular basis or as needed to ensure the best possible performance...
  • Page 2 Supplies (included with the Cleaning Kit) This Cleaning Kit provides you with the specialized cleaning supplies and the required cleaning procedures for you to maintain your Fargo Persona C30 Card Printer/Encoders. The following cleaning procedures will require less than ten minutes. For more thorough cleaning instructions, please refer to the Cleaning Section in the appropriate User Guide.
  • Page 3: Cleaning The Printhead

    Use the Printhead Cleaning Swab to gently rub back and forth over the entire length of the Printhead (3 to 4 times). Once the Printhead is completely dry, replace the Ribbon and close the Front Cover. Persona C30 Card Printer User Guide (Rev. 2.2) IDentiphoto Company, Ltd. 800-860-9111 Fargo Electronics, Inc.
  • Page 4: Cleaning The Platen And The Card Feed Rollers

    This cleaning process will ultimately lead to better print quality and extended Printhead life.) Step Procedure Open the Printer’s Front Cover and remove the Print Ribbon. Persona C30 Card Printer User Guide (Rev. 2.2) IDentiphoto Company, Ltd. 800-860-9111 Fargo Electronics, Inc. sales@identiphoto.com...
  • Page 5 Use the Cleaning Card from the Printer’s and remove the adhesive backing from both sides of the card. (Note: If your Printer has a Magnetic Encoder installed, be sure to leave the small Liner Strip on top of the Cleaning Card in place.
  • Page 6 Insert the Cleaning Card into the Single Feed Card Slot until the card stops. (Note: If your Printer is equipped with a Magnetic Encoder, you must insert the Cleaning Card with the printed side up and with the small Liner Strip towards the front of the Printer.)
  • Page 7: Cleaning The Printer's Interior

    Cleaning the Printer’s Exterior Clean it only with a Cleaning Pad from the Printer’s Cleaning Kit. (Note: The Printer has a durable casing that should retain its luster and appearance for many years.) Persona C30 Card Printer User Guide (Rev. 2.2) IDentiphoto Company, Ltd.