FARGO electronics L000286 User Manual page 201

RESTRICTED USE ONLY
Glossary of Terms (continued)
Term
CR-80
Cursor
Darkness
DC Motor
DC (Direct Current)
Default
Defrag
Dither
Dongle
Dot
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1)
Definition
A card dimension standard of 2.125" X 3.370" (+/-0.002" W, +/-
0.005" L) or 53.975 X 85.598 mm.
The marker in the LCD Display Window that indicates the active
selection.
A reference to color saturation.
A Motor that works on DC with continuous motion. See CardJet
Engineering Drawing No. D400145 in the appendix.
Electronic flow that is unidirectional, flowing from the positive (+)
to negative (-) of a power source.
A setting or parameter that comes preset from the factory in
Driver or Firmware. Performance parameters can be customized
in the Driver, but can be reset to the factory values usually
through the push of the default button. The default values for the
Firmware are usually denoted on a label attached to the Printer.
Abbreviation for defragmenting. The process of reformatting data
on a hard drive so that it uses space more efficiently.
A system of distributing dots to control the hue, brightness and/or
saturation. In monochrome printing, this controls the brightness.
In color printing, dithering can supply a larger color gamut than
non-dithering. In the Driver, dither modes can be selected to
provide better image quality depending on the type of image to be
printed.
A peripheral that attaches to a port to act as a key for an installed
application. The PC is able to run that application only when the
dongle is installed. Typically, it works as a pass-through device
and is connected in serial to the parallel cable.
The smallest unit of an image that the Printer is able to produce.
The smaller the dot, see dot pitch, the sharper the image.
Fargo Electronics, Inc.
Continued on the next page
8-4