Installing The Microsoft Iscsi Initiator - Dell Broadcom NetXtreme Family of Adapters User Manual

complete.
Solution: Install or upgrade the Broadcom Virtual Bus Device (VBD) driver to 5.0.x, along with the OIS driver, prior to
switching the iSCSI boot path.
Problem: If a Windows 2003-based system is booted with an MPIO configuration in the first boot, the interface booted
without a cable attached will not be functional since the IP address of the interface will be statically configured to a value of 0.
This problem only occurs if the TCP/IP parameters are configured as DHCP. in other words, it will not occur if the IP addresses
are statically configured in the iSCSI configuration program.
Solution: Perform the first boot with both cables attached and ensure that both interfaces are able to acquire IP addresses.
Problem: The iSCSI configuration utility will not run.
Solution. Ensure that the iSCSI Boot firmware is installed in the NVRAM.
Problem: A system blue screen occurs when installing the Broadcom drivers through Windows Plug-and-Play (PnP).
Solution. Install the drivers through the Setup installer.
Problem: For static IP configuration when switching from Layer 2 iSCSI boot to Broadcom iSCSI HBA, then you will receive
an IP address conflict.
Solution. Change the IP address of the network property in the OS.
Problem: After configuring the iSCSI boot LUN to 255, a system blue screen appears when performing iSCSI boott.
Solution. Although Broadcom's iSCSI solution supports a LUN range from 0 to 255, the Microsoft iSCSI software initiator
does not support a LUN of 255. Configure a LUN value from 0 to 254.
iSCSI Crash Dump
If you will use the Broadcom iSCSI Crash Dump utility, it is important to follow the installation procedure to install the iSCSI
Crash Dump driver. See
iSCSI Offload
iSCSI offload is a technology that offloads iSCSI protocol processing overhead from host processors to the iSCSI host bus
adapter to increase network performance and throughput while helping to optimize server processor utilization.
This section covers Broadcom's iSCSI offload feature for the NetXtreme II family of network adapters. For Linux iSCSI offload,
see Linux iSCSI Offload.
Configuring iSCSI Offload
With the proper iSCSI offload licensing, you can configure your iSCSI-capable NetXtreme II network adapter to offload iSCSI
processing from the host processor. The following process enables your system to take advantage of Broadcom's iSCSI
offload feature.
Installing Broadcom Drivers and Management Applications

Installing the Microsoft iSCSI Initiator

Configuring Broadcom iSCSI Using BACS 3
Configure Microsoft Initiator to Use Broadcom's iSCSI Offload
Installing Broadcom Drivers and Management Applications
Install the Windows drivers and management applications. See
Installing the Microsoft iSCSI Initiator
Install the Microsoft iSCSI Software Initiator, version 2.08 or later, on Windows Server 2003. For Windows Server 2008 and
later, the iSCSI initiator is included inbox. To download the iSCSI initiator from Microsoft, go to
http://www.microsoft.com/downloads/details.aspx?familyid=12cb3c1a-15d6-4585-b385-befd1319f825&displaylang=en
locate the direct link for your system.
Configuring Broadcom iSCSI Using BACS 3
The Broadcom Advanced Control Suite (BACS 3) is used to manage all of Broadcom's network adapters and advanced
Using the Installer for more information.
Installing Windows Drivers and Management Applications.
and