Dell Broadcom NetXtreme Family of Adapters User Manual page 19

where
drive is the drive letter of the CD-ROM drive.
NOTE: The B57udiag.exe file is on the installation CD or in the DOS Utilities package available from
http://support.dell.com/.
3. Type:
b57udiag -mba [ 0-disable | 1-enable ] -c devnum
where
devnum is the specific device(s) number (0,1,2, ...) to be programmed.
Configuring the MBA Driver
NOTE: You can use the MBA Configuration Menu to configure the MBA driver one adapter at a time as described below, or
you can use the Broadcom NetXtreme User Diagnostics MS-DOS based application to simultaneously configure the MBA driver
for multiple adapters.
1. Restart your system.
2. Press CTRL+S within 4 seconds after you are prompted to do so.
NOTE: The message prompting you to press CTRL+S is displayed once for each Broadcom NetXtreme Gigabit
Ethernet adapter you have in your system. The messages are displayed in the same order as the assigned adapter
device number.
3. Use the UP ARROW and DOWN ARROW keys to move to the Boot Protocol menu item. Then use the RIGHT ARROW or
LEFT ARROW key to select the boot protocol of choice if other boot protocols besides Preboot Execution Environment
(PXE) are available. If available, other boot protocols include Remote Program Load (RPL) and Bootstrap Protocol
(BOOTP).
NOTE: If you have multiple adapters in your system and you are unsure which adapter you are configuring, press
CTRL+F6, which causes the port LEDs on the adapter to start blinking.
4. Use the UP ARROW, DOWN ARROW, LEFT ARROW, and RIGHT ARROW keys to move to and change the values for
other menu items, as desired.
5. Press F4 to save your settings.
6. Press ESC when you are finished.
Setting Up the BIOS
To boot from the network with the MBA, make the MBA enabled adapter the first bootable device under the BIOS. This