Dell Broadcom NetXtreme Family of Adapters User Manual page 136

Reboot the system after the adapter has been added.
Problem: The Broadcom NetXtreme Gigabit Ethernet adapter may not perform at optimal level on some systems if it is added
after the system has booted.
Solution: The system BIOS in some systems does not set the cache line size and the latency timer if the adapter is added
after the system has booted. Reboot the system after the adapter has been added.
Problem: Large Send Offload (LSO) and Checksum Offload are not working on my team.
Solution: If one of the adapters on a team does not support LSO, LSO does not function for the team. Remove the adapter
that does not support LSO from the team, or replace it with one that does. The same applies to Checksum Offload.
Problem: When using the TG3 driver and Red Hat 4 (with any release prior to release 6), after setting the speed and duplex
with ethtool, autonegotiation is disabled and cannot be restored.
Solution: Unload or reload the TG3 driver, or upgrade to the latest version of ethtool.
Problem: A DCOM error message (event ID 10016) appears in the System Even Log during the installation of the Broadcom
adapter drivers.
Solution: This is a Microsoft issue. For more information, see Microsoft knowledge base KB913119 at
http://support.microsoft.com/kb/913119.
Please read all Restrictions and Disclaimers.
Back to Contents Page