Intermediate Driver (Virtual Adapter/Team) - Dell Broadcom NetXtreme Family of Adapters User Manual

network cable is properly
connected.
5 The network link is up.
Network controller
6 configured for 10Mb half-
duplex link.
Network controller
7 configured for 10Mb full-
duplex link.
Network controller
8 configured for 100Mb
half-duplex link.
Network controller
9 configured for 100Mb full-
duplex link.
Network controller
10 configured for 1Gb half-
duplex link.
Network controller
11 configured for 1Gb full-
duplex link.
12 Medium not supported.
Unable to register the
13
interrupt service routine.
14 Unable to map IO space.
Driver initialized
15
successfully.
NDIS is resetting the
16
miniport driver.
Unknown PHY detected.
17 Using a default PHY
initialization routine.
This driver does not
support this device.
18
Upgrade to the latest
driver.
19 Driver initialization failed.

Intermediate Driver (Virtual Adapter/Team)

Table 10 lists the event log messages supported by the intermediate driver, explains the cause for the message, and provides
the recommended action.
Table 10. Intermediate Driver Event Log Messages
System
Event
Message
Message
Number
1 Unable to register with NDIS.
Unable to instantiate the
2
connection with its link partner.
The adapter has established a
link.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The adapter has been manually
configured for the selected line
speed and duplex settings.
The operating system does not
support the IEEE 802.3 medium.
The device driver cannot install
the interrupt handler.
The device driver cannot allocate
memory-mapped I/O to access
driver registers.
The driver has successfully
loaded.
The NDIS layer has detected a
problem sending/receiving packets
and is resetting the driver to
resolve the problem.
The driver could not read the PHY
ID.
The driver does not recognize the
installed adapter.
Unspecified failure during driver
initialization.
Cause
The driver cannot register
with the NDIS interface.
The driver cannot create a
that the link partner (for example, switch or hub)
is working correctly.
Informational message only. No action is required.
Informational message only. No action is required.
Informational message only. No action is required.
Informational message only. No action is required.
Informational message only. No action is required.
Informational message only. No action is required.
Informational message only. No action is required.
Reboot the operating system, run a virus check,
run a disk check (chkdsk), and reinstall the
operating system.
Reboot the operating system; remove other device
drivers that may be sharing the same IRQ.
Remove other adapters from the system, reduce
the amount of physical memory installed, and
replace the adapter.
Informational message only. No action is required.
Run Broadcom Advanced Control Suite 3
diagnostics; check that the network cable is good.
Replace the adapter.
Upgrade to a driver version that supports this
adapter.
Reinstall the driver, update to a newer driver, run
Broadcom Advanced Control Suite 3 diagnostics, or
replace the adapter.
Corrective Action
Unload other NDIS drivers.
Reboot the operating system.