ProScan PS35652 Owner's Manual page 58

Troubles sometimes are caused by simple "faults" that you
can easily correct without the help of a service technician by
first checking a few basic remedies.
Before you call or take your unit to an Authorized ProScan
TV Servicenter, look below for the type of trouble you are
experiencing. Then perform the simple checks and
adjustments listed for that trouble.
TV will not turn on
• Check to make sure it is plugged in.
* Check the wall receptacle (or extension cord) to make sure
it Is I e by plugging in something else.
• Maybe batteries in remote control are "dead".
• Maybe remote control was not aimed at remote sensor.
• Make sure power cord is tully inserted into back of TV.
Controls don't work
• If using remote control, make sure remote is in "TV Mode'"
by first pressing TV button.
• Try unplugging set for two minutes and then turning it on
again.
• Make sure power cord is fully inserted into back of TV.
Intermittent or no remote
• Maybe something was between the remote and the remote
sensor.
• Maybe the remote was not aimed directly at the component
(TV oz"VCR) you were trying to control.
• Maybe remote is not in "TV Mode". Press the TVbutton so
remote will control TV.
• Maybe batteries in remote are weak or dead. Try replacing
batteries,
• Maybe batteries were installed inconectly. Try replacing
batteries correctly.
Turns off while playing
•
SLEEPTIMERtunction may have been activated.
• ALARM OFFfunction may have been activated.
• Electronic protection circuit may have been activated because
of a power surge. Wait 30 seconds and then turn on again. If
this happens frequently, the voltage in your house may be
abnormally high.
• Make sure power cord is fully inserted into back of TV.
Turns on unexpectedly
•
ALARM ONfunction may have been activated.
AmaM does not turn off TV at correct time
• Check ALARM ON/OFFfunction. Must be set to oN,
• Check to make sure CLOCK function is set to the correct time.
Blank screen
* Maybe Channel 90, 91, or 92 is selected, but device connected
to those INPUTjacks is not turned on.
• Try another channel.
No sound, picture okay
• Maybe sound is muted.
Try pressing VOLUMEup button m
restore sound.
° Maybe TV's speakers
are turned off. Check SPEAKERS ON/OFF
function.
• If using channel 90 (s-vlaEO input) with an S-VHS component,
remember to also connect the component's L and R AUDIOOUT
jacks to the TV's L and a INPUT1 jacks.
• Maybe SPEAKERswitch on back of TV is not in the INTERNAL
position.
Can't select certain channel
• Channel may not be in Channel Memory. Try pressing two
number buttons.
• If using a VCR, check to make sure the TV/VCRswitch on the
VCR is in the correct position.
• To select cable channels 100 through 128, press number
button 1 until 1-- appears. Then press the other two number
buttons. The CABLE/AIR function must be in CABLEmode to
select channels higher than 69.
54