ProScan PSVR64 Owner's Manual page 32

Piayin_ a Tape
DISPLAY Button
.
2.
3.
Press DISPLAY to display the status of the VCR, channel
number, time counter, date, time, and tape speed on the TV
screen. The time will appear in the display panel.
The time and date must be set before they are displayed. If you
do not press DISPLAY again, these displays will time out.
Press DISPLAY again to have only the time counter remain
on the TV screen. The time counter will appear instead of
the time in the VCR's display panel.
Press DISPLAY again to remove the time counter from the
TV screen.
The time counter will remain in the VCR's display panel and
no status displays will appear on the TV screen. This is
convenient for editing tapes.
4. Press DISPLAY again to return to the normal status displays.
Turning off the VCR automatically returns the displays to
normal.
Time Counter
The time counter shows the actual time it takes to record a program
or play back a segment of a prerecorded tape. Ithelps locate the
beginning or end of programs you taped. The time counter resets to
0:00:00 whenever the tape is ejected from the VCR.
For example, if a 30-minute program was recorded at the beginning
of the tape, you would:
1. Insert the prerecorded tape. Press STOP. Make sure the tape
is rewound.
2. Press DISPLAY twice .to display only the time counter on the
TV screen.
3. Press CLEAR to reset the time counter to 0:00:00.
4. Press FF on remote or turn the shuttle On the VCR clockwise
to fast forward the tape until the time counter reads 0:30:00.
Press STOP.
This is the approximate end of the program and you can begin
recording at this spot.
5. Press DISPLAY twice to remove the time counter from the
screen and return to the normal displays.
28
S TOP CH 05 0 ."30 : O0 ,:!i:i!iiiii!i_iiiZi!i_iii_ii_i:i_iii_
Status Displays
Will Time Out
:iiiiiiiiii_i i:_iii!i
11118195 Sat 01:30AN SLP