ProScan PSVR64 Owner's Manual page 22

Using the Remote Control
TV Function Buttons
Press the TV button to set remote to control a compatible TV. Some buttons may not work with the TV.
Arrow Buttons ( /x_,_] )
Allow you to move through the menus, enter
data and change settings of selected features.
CHAN Up or Down
Selects next higher or lower channel in the
TV's channel memory when remote is set to
control a TV.
CLEAR
Removes menus or status displays from the
screen.
DISPLAY
Shows the status displays on the screen.
Removes menus or displays from the screen.
MUTE
Turns the TV sound on or off.
Numbers (0 through 9 )
Select a channel up to 99 by pressing two
numbers.
Select a cable channel over 99 by pressing
and holding 1 until 1- - appears on the
screen. Then press the other two numbers.
POWER
Turns off a compatible TV when
remote is set to control TV.
Used with TV button to turn on a
compatible TV, other than
ProScan, when the remote is
programmed to control that TV.
(See page 20.)
PREV CH (Previous Channel)
Switches between two channels.
Select one channel and then use
the number buttons to select
another. Press PREV CH to
switch between the two channels.
SLOW - / +
Used with the TV's menus to
select and adjust features.
VOL Up and Down
Raises and lowers sound.
y oPuw BEAR_H
MgrE CHaR PR_
bbb
6--6 5 -B
Cable Box or RCA DSS ® Satellite Receiver Function Buttons
Press the DSS.CABLE button to set remote to control a compatible cable box or RCA DSS ® satellite
receiver. Some buttons may not work with every cable box. If you have an RCA DSS ® receiver, test the
"TV Function Buttons" to see which ones operate the RCA DSS ® receiver.
CHAN Up or Down
Selects next higher or lower channel.
Numbers (0 through 9)
Select a channel using the number buttons.
POWER
Turns off a compatible cable box or satellite
receiver.
DSS® is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corporation.
18