ProScan PSVR64 Owner's Manual page 25

Controlling a Cable Box or an RCA DSS ® Receiver
Controlling a Cable Box or an RCA DSS ® Receiver
The DSS.CABLE button on the VCR's remote is preprogrammed to control either a compatible RCA cable box or RCA
DSS® satellite receiver. If your cable box is another manufacturer's brand and has its own remote, you will probably be
able to program the VCR's remote to control your cable box. To program the VCR's remote, enter the code that
corresponds to your brand.
Program the Remote for a Cable Box
1. Turn on the cable box.
2. Point the VCR remote at the cable box.
3. Hold the DSS .CABLE button and press two number buttons to enter the code for your brand.
4. Release the buttons.
5. Press POWER on the remote. If the cable box turns off, setup is complete.
6. Repeat steps 2 - 5 with a different code if the first one does not work.
Randtek =
RCA _2.7
Operate the Cable Box or RCA DSS ® Satellite Receiver
After you have setup your remote (if required) to control your cable box, test the buttons to seewhich ones operate your
cable box or satellite receiver.
1. Point the remote at the cable box or satellite receiver and press DSS • CABLE.
2. If the cable box does not turn on in step 1, press DSS. CABLE and then POWER.
If the RCA DSS ® satellite receiver does not turn on in step 1, reprogram the remote using 00.
3. Use the "Cable Box or RCA Receiver Function Buttons" for the cable box and test the "TV Function Buttons" to
see which ones operate the satellite receiver box. (See page 18.)
DSS ® is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corporation.
21