ProScan PSVR64 Owner's Manual page 17

St a rtu
Manual Channel Search
If you ever need to manually Auto Channel Search because you change cable
or antenna signals:
1. Press MENU-PROG to display the VCR MAIN MENU on the TV
screen. If this menu does not appear:
• Make sure TV is tuned to same channel as the CH3 CH4 switch on the
back of the VCR or the TV's video input (refer to TV's manual).
• Press VCR1, then press MENUoPROG again.
• If you use a basic hookup, check VC R indicator in display panel - it
should be on. Press TV •VCR to turn it on.
• Check the connections.
2. Press 4 to display the CHANNELS menu.
3. Press I to begin Auto Channel Search.
The VCR automatically selects CABLE (cable TV) or ANTENNA. If you
need to change the setting manually, press 3. •
f
]
VCR MAIN MENU j
I
I VCR PLus+
• 2 Timer Recordings
3 Time
CHANNELS
2 Add/Remove ChanneLs
SignaL Type: CABLE
• .CabLe/DSS Setup
5 VCR PLus+ Channel List,
0 Exit
Manual Clock Set
If the auto clock set was unsuccessful or you want to manually set the clock,
follow the steps below.
If you set the clock manually during setup, Auto Clock Set will be set to OFF.
1. Press MENU°PROG on remote to display the VCR MAIN MENU on
the TV screen.
2. Press 3 to point and select the TIME menu.
3. Press I to display Set Time and Date.
4. Enter the time and date with the number buttons on the remote.
• Press 0 before single-digit numbers.
Example: press 0, then 5, then 0, then 7 for a time of 5:07. Press 1 for
AM or 2 for PM.
l Press CLEAR on the remote to change incorrect entries.
5. Press MENU °PROG on remote to remove SET CLOCK from the TV
screen and start the clock. The time will appear in the VCR's display
panel and the time and date will appear on the TV screen when you
press DISPLAY.
VCR MAIN MENU
I VCR PLus+
2 Timer Recordings
l
.................
TIME
SET cLocK
Time ......
(hh mm)
bate --/--/--
Press MENU to exit
13