A/V Receiver (Stereo System); Satellite Receiver Or Other Device With Swideo - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Connecting an A/V Receiver (Stereo System}
Connecting a Satellite Receiver or Other Device with S -Video
A/V Receiver (Stereo System}
Figure 7
A digital audio cable and stereo audio cables are required.
These cables are not included with the TV.
1, To connect an analog A/V receiver:
Connect a set of stereo audio caMes from OUTPUT
AUDIO 2 on the TV back paneHto the TV AUDIO
INPUT on the back of the AiV receiver. The red cabHe
connects to the R (right) channeH and the white cabHe
connects to the L (Heft)channel
2. To connect a digital A/V receiver with Dolby®
Digital surround sound:
Connect one end of the digitaH audio cabHe suppHied
with the TV to DIGITAL AUDIO on the back of the
TV. Connect the other end to the COAXIAL DIGITAL
INPUT on the back of the AiV receiver.
Check the A/V receiver's Owner's Guide for information
concerning use of the digital input and switching between
digital sound and analog stereo sound from the TV.
A/V Receiver Rear Panel
Use only if
connecting a
Dolby digital F_';_
A/V receiver=
t.
Section 2.
Figure 7. Connecting an A/V receiver
Note: On rare occasions, an HDMI signal may be copy-
restricted and cannot be output from the TV as a digital
signal. To hear these copy-protected signals through the
AiV receiver, use connections for analog AiV receivers.
MP3 audio from memory cards cannot be connected
to digital audio. To listen to MP3 playback from the TV
MediaCommand memory card player through your A/V
receiver, use the connections for an analog AiV receiver.
Satellite Receiver or Other Device with
S-Video
Figure 8
An S-Video cable and audio cables are required. These are not
included with the T_I
1_ Connect an S-Video cable from VIDEO OUT on the
satellite receiver back panel to INPUT-2 S-VIDEO on
the TV back panel.
2_ Connect a set of audio cables from AUDIO OUT on
the satellite receiver back panel to INPUT-2 AUDIO
on the TV back panel The red cable connects to
the R (right) channel and the white cable connects to
the L (left) channel.
Note: Refer to the Satellite Receiver Owner's
Guide for Dish Antenna connections
Figure 8.
iii!
iiii_
Connecting a Sate!rite Receiver with S-Video
Note: NetCommand® will assume you connected
your Satellite Receiver to Input-2. If you add a second
Satellite Receiver or use any other inputs for your
Satellite Receiver, this change must match in the
NetCommand system. See Editing NetCommand
Setup in Chapter 3 for more information.
Chapter 2. Connecting