Battery Installation; Care; Sleep Timer - Mitsubishi Mr.Slim WD-52627 Owner's Manual

Remote Control, continued
DEVICE CHANNEL VOLUME
CANCEL
°
CONNECT
REW/REV FF/FWD
PLAY
Figure 1. Remote Control Overview
Battery Installation
Figure 2
2_
Remove the remote control's back cover by gently
pressing the ribbed tab in the direction of the arrow
and sliding off the cover.
Load the batteries, making sure the polarities (+) and
(-) are correcL For best results, insert the negative (-)
side firsL
_AA (aUkaUine)
batteries
Care
For Best Results from the Remote Control:
Be within 20 feet of the equipment.
Do not press two or more buttons at the same time
unless instructed.
o Do not allow unit to get wet or become heated.
Avoid dropping on hard surfaces.
Do not use harsh chemicals to dean. Use only a soft,
lightly moistened cloth.
Do not mix new and old batteries.
Do not heat, take apart or throw batteries into fire.
Use only AAA alkaline batteries.
Hint: If the remote is in the TV layer and does
not function, press POWER and 935 to reset the
remote.
SJeep Timer
Setting the Sleep Timer:
1_ Press SLEEP on the remote control
2_ Each additional press of SLEEP increases the time
displayed by 30 minutes, until the maximum value of
120 minutes is reached.
3_ After 5 seconds of inactivity, the message wi[[
disappear.
4. Press SLEEP to view the remaining time before the
timer turns the TV of L
Cancelling the Sleep Timer:
1_ Press SLEEP to display the on-screen message.
2_ Press SLEEP repeatedly until OFF is disp[ayed.
Note: After 5 seconds of inactivity, the message
box disappears.
Figure 2. Operation: installing the Batteries
Chapter 1. Tetevision Overview