Pc Viewing; Features - Mitsubishi Mr.Slim WD-52627 Owner's Manual

PC Viewing
Figure I
To dispHay your PC screen on the TV, first connect
the PC to the HDMI 2 input on the TV's back paneH
(see Chapter 2). You must then activate the PC
option in NetCommand. You can do this during initiaH
NetCommand setup (in the Device Setup screen), or
at any time afterwards by using the NetCommand Add
function. You will then be abHeto seHect the PC through
the Device SeHecfion Menu. For the correct screen
resoHution (pixeHs), use the PC's ControH PaneHsettings.
Your Mitsubishi TV can dispHay resoHutions from standard
VGA (640 x 480) through XGA 60-Hz refresh rates onHy.
See Appendix B in this book for more screen resoHutions.
The instructions bellow are for most PCs.
1. In the PC's "Start" menu, seHect "Settings."
2. SeHect "ControH PaneL"
3. SeHect "Display."
4. Choose the "Settings" tab.
5. Depending on your PC, either:
3_
Use the Screen area slider or use the Screen Resolution
slider to adjust the resolution.
You may need to restart the PC for this change to take
effect.
Hint: You may want to set the computer's screen saver
to a pattern, to display after several minutes, as a
reminder that the TV is stiff powered on and time is
being added to the lamp's elapsed hours, Even ff the
screen appears dark, if the TV's power is on, the lamp
is //Iuse.
&
-5,
Figure 1. PC resolution XGA selection
Chapter 6. Additional Features 85