Mitsubishi Mr.Slim WD-52627 Owner's Manual page 49

Edit NetCommand®: Add Devices, continued
[Device] Screen
Figure 17
If you seHected "None", during initiaHsetup, then you can
add a device, if you have added a new device, seHect
"Other" as the manufacturer and use this screen to start
Hearning.
Our exampHes show the choices for adding a VCR,
however, the same type of screens will appear for any
satellite, DVD pHayer,or CaMe Box.
However, NetCommand will not be aMe to controH
this device. Later you may use the "Change" option
in the Setup menu to Hearnthe remote controH signals.
After seHecfing Next>, the screens that follow are: the
Name Screen (Figure 20), Connection screen (Figure
21) and speciaHized device screens (Figures 22-24),
ending with the Finish screen (Figure 27).
[Device] Learn Screen
Figure I8
Shown only if "Learn" was selected
1. Press ADJUST ,A _' _ I_ to select the check box for
each function to be learned.
2_
Figure IZ [Device] screen
Choose ONE of these options:
Select a recognized manufacturer. The model
number optimized for NetCommand will display at
the bottom of the screen. If a number follows the
manufacturer's name, (example: Mitsubishi 1), this
indicates additional models are optimized for that
manufacturer. For many device types, non-listed
models will operate in the same way as the listed
models and you can still use the preqoaded setting.
After selecting Next>, the screens that follow are: the
Name Screen (Figure 20), Connection screen (Figure
21) and specialized device screens (Figures 22-24),
ending with the Finish screen (Figure 27).
Select "Other", then highlight "Learn" and press
ENTER. This will allow you to have NetCommand
learn the remote control signals of this new device.
After selecting "Learn" and pressing ENTER, the
screens that follow are: [Device] Learn screen (Figure
18), [Device] Advanced Learn screen (Figure 19),
Name screen (Figure 20), Connection screen, (Figure
21) and specialized device screens (Figures 22-24),
ending with the Finish screen (Figure 27).
Select "Other", skip Learn and select Next>. This
will allow the device to appear and will allow
NetCommand to switch inputs to use this device.
3_
4_
Press ENTER and the function name will begin to
flash to confirm the ready-to-learn status.
Press the button on the device's remote control that
corresponds to the selected function. A check mark
will appear and the function name will stop flashing.
This confirms the signal learned status.
To test the learned command, press the ENTER
button on the TV remote while the learned function
is still higHighted. The device should perform the
selected function. The device needs to be turned on
and the IR emitters properly placed for the test to be
successful (see page 32 for IR emitter placement).
5. Repeat for each function to be learned.
6. To erase a learned function, highlight the check box
for that function and press CANCEL
7. When the function signals have been learned, press
ADJUST _ to select Next> and move to the [Device]
Advanced Learn screen.
NOTE: When learning the device's remote control
signals, point the device's remote control at the TV
screen.
Hint: If the device's remote control uses a single button
for both Power On and Power Off, don't learn the Power
Off function,
Chapter 3. NetCemmand Setup and Editing
49