Mitsubishi Mr.Slim WD-52627 Owner's Manual page 51

Edit NetCommand®: Add Devices, continued
The screens described beJow may not be necessary for your device setup, Jf they do not
dispJay automatically on screen, they are not required.
VCR for Recordings Screen
Figure 22
SeHect the VCR to use for making anaHog recordings
through NetCommand or the TV Guide On Screen®
system. The VCR inputs must be connected to RECORD
OUT on the TV, which outputs anaHog signaHs converted
from digital
Figure 22. VCR for Recordings screen
JR Code for [Device] Screen
Figure 24
This screen onHydisplays if an added device has the
same JRcode as a previousHy added device of the same
type and manufacturer. You can specify the IR setting for
the new device. For exampUe, for the second Mitsubishi
VCR you can specify the IR Code setting to VCR-B, if the
primary Mitsubishi VCR is using the VCR-A IR code.
RF Connection for CabJe Screen
Figure 23
The RF Connection for Cable screen displays only when
adding or changing a Cable Box. If your Cable Box is
connected to a TV Antenna input, check the RF check
box. Select the TV antenna input that is used with the
Cable Box. Select the channel number used for output
by your cable box from the choices listed (003,004, 005).
If the Cable Box is also connected to a VCR for recording,
select that VCR.
If your Cable box is connected using Audio/Video or
component cables, make sure the RF check box is
unchecked. Then the next screen will be Connection
(Figure 20), to allow the selection of the TV input used
with the Cable Box.
Figure 23. RF Connection for Cable screen
Figure 24. IR Code for [Device] screen
Chapter 3. NetCommand Setup and Editing