A/V Receiver; Satellite Receiver Or Other Device With S-Video; A/V Receiver Or Stereo System - Mitsubishi WD-52528 Owner's Manual

Connecting an A/V Receiver (Stereo System)
Connecting a Satellite Receiver or Other Device with S -Video
A/V Receiver (Stereo System)
Figure 7
A coaxial digital audio cable or stereo audio cables are required.
These cables are not provided with the TV.
• To connect an analog A/V receiver:
Connect a set of stereo audio cables from OUTPUT
AUDIO 2 on the TV back panel to the TV AUDIO
INPUT on the back of the A/V receiver. The red cable
connects to the R (right) channel and the white cable
connects to the L (left) channel.
• To connect a digital A/V receiver with Dolby®
Digital surround sound:
Connect one end of a digital audio cable to DIGITAL
AUDIO on the back of the TV. Connect the other end
to the COAXIAL DIGITAL INPUT on the back of the

A/V receiver.

COMPONENT
INPUT YPbPr (480i/480p/720p/1080i)
1 2 3
1 2
INPUT
Y
DVI
Analog Audio
S-VIDEO
Pb
1 2
VIDEO Pr
AUDIO-
AUDIO-
LEFT/
LEFT/
(MONO)
(MONO)
AUDIO- AUDIO-
RIGHT RIGHT
MONITORLINK™/HDMI
VIDEO 480i/480p/720p/1080i
AUDIO PCM LINEAR
1
2
IR EMITTER
Net Command
DTV/CABLE/
VHF/UHF
USE WITH
DIGITAL
CableCARD TM AUDIO
OUTPUT CableCARD™ ANT 1 CARD TOP
ANT 1 / MAIN ANT 2 / AUX USE WITH
Figure 7. Connecting an A/V receiver
Note: On rare occasions, an HDMI signal may be
copy-restricted and cannot be output from the TV
as a digital signal. This is not anticipated to be a
common situation. To hear these copy-protected
signals through the A/V receiver, use connections
for analog A/V receivers.
28
Chapter 2. Connecting
OUTPUT
AUDIO RECORD
OUTPUT OUTPUT
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
SERVICE
PORT
IEEE 1394
INPUT/
OUTPUT
Satellite Receiver or Other Device with
S-Video
Figure 8
An S-Video cable and audio cables are required. These are not
included with the TV.
1. Connect an S-Video cable from VIDEO OUT on the
satellite receiver back panel to INPUT-2 VIDEO on the
TV back panel.
2. Connect a set of audio cables from AUDIO OUT on the
satellite receiver back panel to INPUT-2 AUDIO, on the
TV back panel. The red cable connects to the R (right)
channel and the white cable connects to the L (left)
channel.
Note: Refer to the Satellite Receiver Owner's Guide
for Dish Antenna connections.
Figure 8. Connecting a Satellite Receiver with S-Video
Note: NetCommand® will assume you
connected your Satellite Receiver to Input-2. If
you add a second Satellite Receiver or use any
other inputs for your Satellite Receiver, this
change must match in the NetCommand system.
See Editing NetCommand Setup in Chapter 3 for
more information.
INPUT
1 2
S-VIDEO
VIDEO
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT