Recordings - Mitsubishi Mr.Slim WD-52627 Owner's Manual

NetCommand®oControHed Recordings
Setting up Recordings
Figure 13
Through NetCommand, you can automatically start and
stop recordings and send signaHs from one pHayback
device to a recording device. Recordings can be made
on recordabHe devices connected to the TV.
The TV can convert digitaH channeHs and JEEE1394
device signaHs to anaHog signaHs that can be recorded on
NetCommand compafibHe anaHog VHS and S-VHS VCRs
You can scheduHe the recording to take pHace at a Hater
time and program the recording duration for a minimum
of 30 minutes and a maximum of 6 hours (in 30 minute
increments). The default is 1 hour. During the recording,
the TV can be powered Of L If the TV is powered On, it
will be tuned to the source that is being recorded. The
TV should remain on this source to ensure the recording
continue without interruption.
Figure 13. Record to screen
Recording Now
Can be used when viewing Antenna 1 or 2, an IEEE 1394
device, or a non-recording traditional device.
To initiate recording now:
1_ Press REC (record) on the TV remote.
2_ In the "Record to" section, review the destination
device and duration. Use ADJUST ,A or V to change,
if necessary.
3_ Press a second time and the recording will starL
Time-DeJayed Recording
1_ Press REC (record) on the TV remote.
2_ Press ADJUST ._ or _ to select the Record to device,
duration time, start time (press ENTER after selecting
hour, minutes and AM or PM to set the time) and day,
using ADJUST A or _Fto change. For devices that
can select channels, select the channel
3_
Select Add and press ENTER to add the recording
to the record list. if your selection is successful, a
confirmation message will be displayed. If you pick
overlapping times, day(s), or destination devices, you
will see a message stating there is a conflicL
4_ To exit, press HOME on the TV remote after all
recordings have been added.
60 Chapter 4. IEEE 1394 Devices and NetOommand=Controtled Recordings