Mitsubishi Mr.Slim WD-52627 Owner's Manual page 61

Record List, Peer-to-Peer Connections
Record List
Figure 14
Press GUIDE wMHeviewing the Record To screen to see a
Histof aH currently programmed recordings. A maximum
of 32 recordings can be scheduHed.
To canceH a recording on the Record List, press ADJUST _.
or V to seHect the recording, then press CANCEL. To page
through the Hist,press CH _ or V.
Figure 14. Record List screen
TV Guide On Screen@ and the Record
Programs scheduHed through TV Guide On Screen will
not appear on this record Hist. Refer to the separate
TV Guide On Screen@ User's Guide for information
regarding Recording and ScheduHes with TV Guide On
Screen.
If there is a conflict between recordings scheduHed
through TV Guide On Screen and the Record List, the TV
Guide On Screen recording will be used.
CanceJ Current Recordings
To cancel a recording in progress, press DEVICE to
display the Device Selection menu and highlight the
source of the recording. Confirm that the icon for VCR (or
recording device) is in the Connection Section next to the
TV icon. Press the CANCEL button. The icon for the VCR
(or recording device) will disappear from the Connection
Section to confirm the cancellation.
PeerttooPeer Connections
A peePto-peer connection allows the IEEE 1394 devices
in your TV network to talk to each other without the
further need of TV intervention once the peer-to-peer
connection is established. For example, the TV can
setup a connection for an AiV Disc or DVCR that sends
a recorded program to an IEEE 1394 monitor in another
room. NetCommand will establish the connection
between the two devices. Once the connection has been
established, the TV can be turned off or used to watch
another device. Recording from digital channels to a
DVCR is also a peer-to-peer connection. In this case, the
TV is one of the devices in the peePto peer connection.
NOTE: Multiple peePto-peer connections can occur
simultaneously, sometimes with the same source
device
Setting up a Peertto-Peer Connection
A peer-to-peer connection is a current connection and
cannot be setup as a delayed connection.
To establish a peer-to-peer connection:
1. Tune to source.
2. Press CONNECT or RECiCONNECT on the TV remote.
3. In the "Record to" section, review the destination
device (example: DVCR) and duration. Change if
necessary.
4. Press CONNECT or REC/CONNECT a second time to
initiate recording.
NOTE: Multiple peer-to-peer connections can
occur simultaneously, sometimes with the same
source device. Also, please note that peer-to-peer
connections are NOT listed on the Record List screen.
CanceJin9 a PeerotooPeer Connection
After a peePto-peer connection has been established,
you can cancel it by highlighting the source device in
the Device Selection menu. Confirm that the on-screen
icon for the peePto-peer connection is in the Connection
Section next to the TV icon, then press CANCEL The
connection will end and the destination icon will be
removed. If there is more than one peePto-peer
connection for the same device, all of the connections
will all be canceled.
Chapter 4. IEEE 1394 Devices and NetCommand=ControHed Recordings