Advertisement
Available languages
Available languages
Oven will not self-clean.
Oven did not clean properly.
Oven door will not unlock after
self-clean cycle.
There are no beeps and
no display.
Moisture collects on oven
window or steam comes from
oven vent.
There is a strong odor or light
smoke when oven is turned on.
Fault Codes
Noises may be heard.
SAb flashing and then
displayed continuously.
Cannot add another Favorite.
• Check to make sure the cycle is not set for a delayed start. See pg. 5.
• Check if door is closed,
• Check if control is in Sabbath Mode, See pg. 26.
• Oven may be over 400° F. Oven temperature must be below 400° F to program a
clean cycle,
• Longer cleaning time may be needed.
• Excessive spillovers, especially sugary and/or acidic foods, were not removed prior
to the self-clean cycle.
• Oven interior is still hot. Allow about one hour for the oven to cool after the
completion of a self-clean cycle, The door can be opened when the LOCKED
indicator word is not displayed,
• The control and door may be locked, See pg. 5.
• Oven may be in Sabbath Mode. See page 26.
• This is normal when cooking foods high in moisture.
• Excessivemoisture was used when cleaning the window.
• This is normal for a new range and will disappear after a few uses. Initiating a clean
cycle will "burn off" the odors more quickly.
• Turning on a ventilation fan will help remove the smoke and/or odor.
• Excessivefood soils on the oven bottom. Use a self-clean cycle.
• The oven may detect a fault during programming or during operation. If a fault is
detected, the message FAULT DETECTED- PRESSPOWERTO CLEAR or FAULT
DETECTED- PRESSENTERTO TRY AGAIN may appear. Follow directions in the display.
If the fault reappears or does not clear, call an authorized servicer or the toll-free
number in the display.
• If the same operation is attempted before having the oven repaired, the message
FEATURENOT AVAILABLE will appear. The feature will remain inoperable until service
is obtained.
• If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEl_ pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
• The oven makes several low-level noises. You may hear the oven relays as they go on
and off. This is normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
• Oven is in Sabbath Mode. To cancel, press and hold the Setup pad for five
seconds.
• Favorites is full. To delete a favorite and add another, see page 26.
10
Advertisement
Chapters
