Table of Contents
Advertisement
100
Appendix A - Installing System Software
6.
Select Install. When prompted, confirm the path to the directory in
which the driver will be installed.
7.
If prompted to choose between the installed driver and a new driver,
select New.
8.
When the MGA Monitor Selection dialog displays, you may select a
monitor as described in Chapter 2, "Configuring the System," to
obtain higher screen refresh rates (greater than 60 Hz).
9.
Restart the system.
Refer to Chapter 2, "Configuring the System," for information on
configuring the G95 video display driver. Refer to the Windows NT
Workstation System Guide for more information about installing and
configuring video display drivers.
q
Install the sound driver
To install the sound driver:
1.
Open Drivers in the Windows NT Control Panel. The Drivers dialog
displays.
2.
Select Add. The Add dialog displays.
3.
Select
Creative Labs Sound Blaster 1.X, Pro, 16
list, and select OK. The Install Driver dialog displays.
4.
Insert the Windows NT CD-ROM into the CD-ROM drive.
5.
Type the location of the driver into the Install Driver dialog as
follows, where drive is the location of the CD-ROM drive:
drive:\i386
6.
Select OK. The Sound Blaster Base I/O Address dialog displays.
Make sure the DMA Channel (16_Bit) setting is set to 5.
7.
Select the port to use for the sound driver (the default is 220), and
select Continue.
8.
Select OK.
from the
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TD-300 and is the answer not in the manual?