Re-Installing System Software; Observing System Precautions - Intergraph TD-300 Maintenance Manual

Re-install Windows NT Workstation with the NTFS file system.
You should change to NTFS immediately after setting up the system, before
you install applications programs and begin creating files and directories.
When using CONVERT.EXE, you must manually set permissions on files
and directories; this occurs automatically when re-installing the operating
system with NTFS. For more information on converting file systems, refer
to the Windows NT Workstation Installation Guide. For more information
on securing directories and files, refer to the online Windows NT
Workstation System Guide.
For information on software installed on a system running the Solaris 2.5 for
x86 operating system, refer to Intergraph's Workstation Software
Configuration for Solaris 2.5 for x86 (delivered with Intergraph workstations
running Solaris 2.5 for x86).

Re-Installing System Software

If you need to re-install the Windows NT Workstation or Windows 95
operating system for any reason, refer to Appendix A, "Installing System
Software" for instructions.
For instructions on re-installing the Solaris 2.5 for x86 operating system,
refer to Intergraph's Workstation Software Configuration for Solaris 2.5 for
x86 (delivered with Intergraph workstations running Solaris 2.5 for x86).

Observing System Precautions

Observe the following precautions when using the system.
When restarting the system, use the operating system controls instead of
pressing the reset button or turning the power switch off and on. Use the
reset button and power switch only when instructed, or as the last
alternative for restarting the system.
Never turn the base unit off when the disk access LED is on.
After powering off the base unit, wait at least 30 seconds before
powering on again to allow the system to power cycle.
Chapter 1 - Getting Started 11