Windows Nt Workstation 4.0 - Intergraph TD-20 Setup Manual

28

Windows NT Workstation 4.0

Depending on your system's configuration, you will need some or all of the following system
software (on backup diskette or on the operating system CD-ROM) during installation:
u
SCSI adapter driver
u
G76, G95, or Intense 3D Pro video display driver
u
Network adapter driver
u
Sound processor driver
u
Mouse driver
u
QFE update software
NOTE When installing the G76 video display driver from the Windows NT Workstation 4.0
CD-ROM, note that the driver is listed as an "S3 732/764/765 compatible" driver.
NOTE TD-20 and TD-200 systems have different sound processors and require different sound
processor drivers. TD-20 systems use the Sound Blaster driver; TD-200 systems use the
Crystal Audio driver.
Follow the instructions in Start Here to install Windows NT Workstation 4.0. As you install
the operating system:
u
You can safely select the default responses during the Setup process.
u
Allow Setup to configure the network only if you have an installed network adapter, and
then only if the system is connected to the network.
u
When prompted to create an Emergency Repair Disk, do so.
After installing the operating system:
u
Install drivers or other system software from any backup diskettes. System software
delivered on backup diskette is usually more current than system software on the
operating system CD-ROM.
u
If you created a Quick-Fix Engineering (QFE) backup diskette during system
configuration, install the QFE update software. Refer to the
diskette for more information.
u
Configure the system as described in Chapter 3, "Configuring the System."
u
Perform any additional installation and configuration tasks described in the Late-Breaking
News document delivered with your system.
. file on the QFE
README TXT