Before You Start; Remove The Door Assembly; Disassemble The Door Assembly - GE Profile DPVH890 Owner's Manual & Installation Instructions

Installation Instructions
REVERSING THE DOOR SWING (if desired}
BEFORE YOU START
Unplug the drger from its electrical outlet.
F11REMOVE THE DOOR ASSEMBLY
Remove the side hinge cap bg opening
the drger door and removing the screw from
behind the hinge (#8 x .375" tapping screw). Then
using gout hand, pop the hinge cap off the drger.
/
Hinge
F[] REMOVE THE DOOR ASSEMBLY {cont.}
Hold the door and remove the 2 hinge screws
(#10 x 0.75" tapping screws). Pull the door awag
from the drger front panel.
/ i
/' i
// I
t
/ i i
/ i
// i
[_] DISASSEMBLE THE DOOR ASSEMBLY
Lag the door down on a soft, protected, flat
surface so that the inner part faces upward
(door resting on the handle side).
Remove the 7 screws (#10 x :L125" tapping
screws) located around the perimeter of the door.
Turn the door assemblg over and separate
the chrome cover from the inner door. Put
the inner door aside on a soft, protected flat
surface.
34