Test For Leaks; Electrical Requirements For Gas Dryers; Electrical Connection Information - GE Profile DPVH890 Owner's Manual & Installation Instructions

Installation Instructions
CONNECTING A GAS DRYER (cont.)
TEST FOR LEAKS
_k WARNING - Never usean
open flame to test for gas leaks.
Check all connections for leaks with soapy solution
or equivalent.
Apply a soap solution. The leak test solution must
not contain ammonia, which could cause damage
to the brass fittings.
If leaks are found, close the valve, retighten the
joint and repeat the soap test.
OpenGas
Valve
ELECTRICAL CONNECTION
INFORMATION FOR GAS DRYERS
WARNING - To reduce the risk of
fire, electrical shock and personal injurg:
Do not use an extension cord or an adapter plug
with this appliance.
The dryer must be electrically grounded in
accordance with local codes and ordinances,
or in the absence of local codes, in accordance
with the NATIONAL ELECTRICAL CODE, ANSI/NFPA
NO. 70.
ELECTRICAL REQUIREMENTS
FOR GAS DRYERS
This appliance must be supplied with 120V, 60Hz,
and connected to a properly grounded branch
circuit, protected by a 15- or 20-amp circuit
breaker or time-delay fuse.
If electrical supply provided does not meet
the above specifications, it is recommended that
a licensed electrician install an approved outlet.
-_WARNING
- Thisdryer is equipped
with a three-prong(grounding) plug foryour
protection againstshock hazard and should be
plugged directly i ntoa properly grounded three-
prong receptacle. D o not cutor remove the
grounding terminalfrom thisplug.
Ensure proper
ground exists
before use.
If local codes permit, an external ground wire (not
provided), which meets local codes, may be added
by attaching to the green ground screw on the rear
of the dryer, and to an alternate established ground.
Ensure proper ground exists before use.
Ground
Screw
20