Bottom Venting; Adding Cover Plate To Rear Of Cabinet - GE Profile DPVH890 Owner's Manual & Installation Instructions

Installation Instructions
SIDE VENTING (cont.)
ADDING ELBOW AND DUCT FOR EXHAUST
TO LEFT OR RIGHT SIDE OF CABINET (cont.)
• Apply duct tape as
Duct
shown on the joint
between the dryer
internal duct and
the elbow, and also
the joint between the "
elbow and the side duct.
CAUTION: Internal
duct joints must be secured with tape; otherwise,
theg mag separate and cause a safetg hazard.
ADDING COVER PLATE TO REAR OF CABINET
(SIDE EXHAUST)
Connect standard metal elbows and ducts to
complete the exhaust system. Cover back opening
with a plate (Kit WEIM454) available from your
local service provider. Place dryer in final location.
-A WARNING - NEVER LEAVE
THE BACK OPENING WITHOUT THE PLATE.
(Kit WEIM454)
BOTTOM VENTING:
Drger Exhaust to the bottom of cabinet
for Gas and Electric models.
-A WAR N ING - BEFORE
PERFORMING THIS EXHAUST INSTALLATION,
BE SURE TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE
TO WEAR GLOVES.
Remove
screw
and save
X,
Bottom
Remove desired
knockout(oneonly)
Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer. Detach
and remove the bottom knockout.
Fixinghole
..................... A
123A ' ' _I
Cut the duct as shown and keep portion A.
29