ABOUT REVERSING THE DOOR
15
SWING
IMPORTANT NOTES:
· Read the instructions all the way through before starting.
· Handle parts carefully to avoid scratching paint.
· Set screws down by their related parts to avoid using them in
the wrong places.
· Provide a non-scratching work surface for the door. · Normal
completion time to reverse the door swing is 30–60 minutes.
IMPORTANT:
Once you begin, do not move the cabinet until door-swing
reversal is completed. These instructions are for chan- ging
the hinges from the right side to the left side - if you ever
want to switch them back to the right side, follow these same
instructions and reverse all references to the left and right.
Tools Needed
Standard #2 Phillips Screwdriver
Tape-tipped putty knife
Before you start
Unplug the dryer from its
electrical outlet
REVERSING THE DOOR
SWING
SOLID DOOR MODELS:
GTDP740ED0WW
GTDP740GD0WW
GTDL740ED0WW
GTDL740GD0WW
Open the door to approximately 170 degrees.
1
With a putty knife, remove the 4 plastic covers located
along the left side of front panel and set them aside.
Plastic Cap (4)
Installation Instructions
Remove the bottom screw from each hinge (right side) and
2
partially insert them into the top left side hinge holes.
NOTE: All 4 front panel hinge screws will now be in the
top hinge holes - 2 on the left and 2 on the right.
Loosen the bottom 2 right side hinge screws. Remove
3
any damage. Remove both the Blind Plate and the Strike
Plate and install them in opposite positions.
Remove the 4 door hinge screws, 8 edge screws, and 4
4
blade screwdriver.
12