Alarm - EverFocus PowerPlex EDR-920 Installation & Operation Manual

3.4 ALARM MENU

ALARM

ALARM 1
ALARM 2
ALARM 3
ALARM 4
ALARM 5
ALARM 6
ALARM 7
ALARM 8
ALARM 9
SUMMARY
Menu display for EDR-920, EDR1640 identical, but with 16 alarm inputs.
Define the dry alarm contacts' attributes and the alarm reactions in the ALARM menu.
For alarm contact pin assignment, please refer to appendix D.
Each contact is adjusted individually and selected from the list on the left:
(1) ALARM:
ENABLE: Contact is activated.
DISABLE: Contact is deactivated.
(2) ALARM TYPE:
N.O. : Normally open, contact reacts on being connected to ground (GND). Define the
alarm duration within menu item DURATION.
N.C.: Normally closed, contact reacts on being disconnected from ground (GND). Define the
alarm duration within menu item DURATION.
N.O. + Trans.: Transparent mode, similar to normally open but: alarm is active as long as
input contact (but minimal as defined in DURATION)
N.C. + Trans.: Transparent mode, similar to normally closed but: alarm is active as long as
input contact (but minimal as defined in DURATION)
(3) ACTIVE CAMERA:
Alarm camera being recorded and displayed in full screen on the main monitor (see
(10) MAIN MONITOR). Recording is carried out according to the settings defined
for EVENT within the CAMERA menu.
COPY function
Alarm settings can be copied from one contact to another. Select the contact to be copied from the
contact list on the left and press the COPY key. The message "COPIED" appears at the top screen
margin. Select the contact which shall apply the settings from the contact list. Press the SEARCH key to
assign the copied settings to the contact. The message "PASTED" appears at the top screen margin
ALARM ENABLE
ALARM TYPE N.O.
ACTIVE CAMERA 01
DURATION 05 SEC
ALARM OUTPUT NONE
ALARM EMAIL NO
OFF
BUZZER
ALARM NETWORK NO
MAIN MON NO CHANGE
CALL MON NO CHANGE
MATRIX 1 NO CHANGE
MATRIX 2 NO CHANGE
MATRIX 3 NO CHANGE
MATRIX 4 NO CHANGE
36