Video Loss - EverFocus PowerPlex EDR-920 Installation & Operation Manual

3.6 VIDEO LOSS MENU
VLOSS SETUP MENU
CAMERA 1
CAMERA 2
CAMERA 3
CAMERA 4
CAMERA 5
CAMERA 6
CAMERA 7
CAMERA 8
CAMERA 9
SUMMARY
Menu display for EDR-920, EDR1640 identical, but with 16 cameras.
Define the reaction upon video signal loss for each camera in this menu:
(1) VLOSS:
ENABLE: Video loss detection is activated.
DISABLE: Video loss detection is deactivated.
(2) DURATION: Alarm duration. Duration applies to buzzer and output contact and is adjustable
from 1~99 seconds.
(3) ALARM OUTPUT: Output relay activation.
1: Output relay 1 ~ 4 (selection) is switched in case of alarm
NONE: Output relay is deactivated.
(4) ALARM EMAIL: By selecting "ON", an email is sent in case of alarm, containing the alarm
message and the DVR IP address as sender.
Define the email recipiant's details in the NETWORK menu.
(5) BUZZER: Alarm buzzer activation
ENABLE: Alarm buzzer is activated.
DISABLE: Alarm buzzer is deactivated.
(6) ALARM NETWORK: Network alarm function activation. Network alarm reception requires
installation of the optionally available PowerCon software. The network alarm
transmits both the alarm message and the DVR IP address as sender to up to
3 recipiants.
YES: Network alarm is activated.
NO: Network alarm is deactivated.
(10) SUMMARY: The SUMMARY menu item gives a summary on the settings for control purpose.
Use the JOG to browse the individual settings.
ATTENTION: This menu does not allow any editing of settings.
VLOSS ENABLE
DURATION 05 SEC
ALARM OUTPUT 01
ALARM EMAIL NO
BUZZER DISABLE
ALARM NETWORK NO
41