Perma • Lock™ Hardware; Fan Preparation - Casablanca Stealth Instructions Manual

STEALTH INSTALLATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and
check them against the parts listed here. Before discarding packaging material, be certain that all parts have
been removed.
ALLEN SET SCREw
⁄ -20 x
1
4
(PRE-INSTALLED)
IMpOrTaNT saFeTy INFOrMaTION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, IN-
STALL THE THREADED DOwNROD INTO THE MOTOR COUPLING AND
Prepare for fan installation as follows:
Step A. Route the wires from the motor through the
Perma • Lock™ downrod and ball assembly.
Tip: The downrod has a tapered
thread that is designed to lock com-
pletely when correctly installed.
Step B. Using the provided allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning, this will take at least four and a half full turns.
Step C. Securely tighten the set screw with the provided
allen wrench to ensure safe operation of your fan.
CAUTION: failure to fully lock in the downrod
before securely tightening the allen set screw may
cause the fan to separate from the downrod during
normal operation!
PERMA • LOCk™ HARDwARE
⁄ "
1
4
1/8"
ALLEN wRENCH

FAN PREPARATION

LOCk THE ASSEMBLY
S
tealth
MOTOR
wIRES
TAPERED
THREAD
ALLEN
SET SCREw
®
DOwNROD & BALL
ASSEMBLY
GROUND
wIRE
DOwNROD
& BALL
ASSEMBLY
MOTOR
COUPLING
3