Pipe Scroll Hardware; Decorative Scroll Assembly - Casablanca Ceiling Fans Owner's Manual

MOUNTING BRACKET INSTALLATION (CONT.)
Step 3. Align the slotted holes in the ceiling plate
with the pilot holes you drilled in the wood support
structure� For proper alignment use slotted holes
directly across from each other�
Note: The isolators should be flush against the
ceiling�
Step 4. Place a flat washer on each of the two
3" wood screws and pass the screws through the
slotted holes in the ceiling plate into the pilot holes
you drilled�
Step 5. Tighten the screws into the 9/64" pilot
holes; do not use lubricants on the screws� Do not
over tighten�
ALLEN SET
SCREW
Collar
(pre-installed)
Screwdriver
Note: Decorative Scroll Work can only be installed
on ceilings at least 10' high�
Step 1. Using the Allen Wrench, loosen the Set
screw on the collar of the Scroll Assembly�
Step 2. Attach Scroll Arm to Collar with Scroll
Screw�
Step 3. Repeat step 2 until all (5) Scroll Arms are
attached to the Collar�
8
Trim Ring
Canopy

PIPE SCROLL HARDWARE

Decorative Scroll
Screws (5)
Allen
Scroll to Motor
Wrench
Screws (5)

DECORATIVE SCROLL ASSEMBLY

Joist
Ceiling Fan
Approved
Wiring Box
Note: On sloped ceilings, align
the canopy opening toward
the top or peak of the room�
Decorative
Scroll Arm
Scroll Screw
Washer
Wood
Screw
Decorative Scroll
Arm (5)
Collar
Set Screw
Allen
Wrench