Table of Contents
Advertisement
PERMA•LOCK
PERMA•LOCK™ HARDWARE (not to scale)
Allen Wrench
IMPORTANT SAFETY INFORMATION!
Before starting the installation of your ceiling
fan, install the threaded downrod into the motor
coupling and lock the assembly.
Step 8a. Place the motor cover on the downrod as shown.
Step 8b. Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Step 8c. Using the provided Allen wrench, loosen the set
screw several turns to allow installation of the downrod.
Thread the downrod into the motor coupling until it stops
turning. This will take at least four and a half full turns.
Step 8d. Securely tighten the set screw with the provided
Allen wrench to ensure safe operation of your fan.
Step 8e. Align the motor cover keyhole slots with the three
screws in the motor adaptor. Once the cover clears the screw
and washers, turn counterclockwise to engage.
TIP: The downrod has a tapered thread that is designed to
lock completely when correctly installed.
Keyhole Slot
8
HARDWARE INSTALLATION
™
Motor Cover
Perma•Lock™
Downrod
and Ball Assembly
Allen Wrench
Allen
Set Screw
(read caution
below)
FAILURE TO DO SO WILL CAUSE FAN TO FALL
INSTALLER
GIVE THIS TAG TO THE
CONSUMER AFTER
INSTALLATION COMPLETE
TIGHTEN
LOCKSCREW
REQUIRE A GROUND FAULT INTERRUPTER (GFI)
Perma•Lock™
Downrod
and Ball Assembly
Ground Wire
(green)
(leave at least 6" long)
DANGER
IT IS IMPERITIVE THAT THE LOCKSCREW
BE SET TIGHTLY AGAINST THE DOWNROD
THREADS AFTER FAN IS ASSEMBLED
DO NOT OIL SEALED BEARINGS!
INSTALLER
CONFIRM LOCKSCREW
IS PROPERLY TIGHTENED
P/N 1942640 SRB4/96
TIGHTEN
LOCKSCREW
CAUTION
DAMP LOCATION RATED FANS
USE A WEATHER PROOF OUTLET BOX
PROPERLY CONNECT GROUND WIRES
USE ONLY UNDER A WEATHER
PROOF STRUCTURE
Motor Wires
Tapered Thread
Motor
Coupling
Motor Housing
Assembly
Advertisement
Table of Contents
