Installation Instructions; Perma•Lock™ Hardware - Casablanca Wilderness Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them

against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.

ALLEN SET SCREw

⁄

-20 x

⁄

(PRE-INSTALLED)

ImPORTANT SAFETY INFORmATION!

BEFORE STARTINg THE INSTALLATION OF YOUR CEILINg FAN, INSTALL THE

THREADED DOwNROD INTO THE mOTOR COUPLINg AND LOCK THE ASSEmBLY

Prepare for fan installation as follows:

Step A. Place the motor cover on the downrod as shown.

Step B. Route the wires from the motor through the

Perma • Lock™ downrod and ball assembly.

Tip: The downrod has a tapered thread that is designed

to lock completely when correctly installed.

Step C. Using the provided allen wrench, loosen the set screw

several turns to allow installation of the downrod. Thread the

downrod into the motor coupling until it stops turning, this

will take at least four and a half full turns.

Step D. Securely tighten the set screw with the provided allen

wrench to ensure safe operation of your fan.

Step E. Slide the motor cover down so that it is flush against

the top of the fan.

CAUTION: Failure to fully lock in the down-

rod before securely tightening the allen set

screw may cause the fan to separate from

the downrod during normal operation!

Step F. Using the three screws provided, attach

the motor cover to the motor. Tighten firmly by

hand only.