Canopy Hatch Installation; Bulb Installation; Installing The Glass - Casablanca Stealth Instructions Manual

CANOPY HATCH INSTALLATION

Step 6. Tuck the wires into the canopy with the wire nuts
pointed upwards, so that the white and black wires are
on opposite sides of the canopy and all wires are clear
of the canopy opening.
Step 7. Install canopy hatch with the last canopy screw
and lock washer. To do this, tilt the fan body away from
the hatch opening.
Tip: Place the lock washer on the canopy
screw, and the screw through the hatch before
tilting the fan to install the hatch onto the
canopy.
Step 8. Straighten the fan, then check to ensure that
there is no movement between the canopy and ceiling
or Hang-Tru ball and downrod.
Step 9. Screw the 100-watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is ex-
tremely important that the glass be clean. If it is touched,
or dirty, clean carefully with a tissue. A dirty glass bulb
will cause the bulb to fail almost immediately.
IMpOrTaNT! When installing the halogen bulb,
carefully cut off the end of the plastic sleeve the
bulb comes in and hold the bulb by the plastic
sleeve to screw it into the socket.
NOTE: In compliance with US Federal Energy
Regulations, this ceiling fan contains a device
that restricts the light kit to a maximum of 190
watts. Exceeding that limit or the marked limit
on this product may result in a fire hazard or
improper operation.
Step 10. Position the indentations in
the outer rim of the glass so that they
line up with the tabs on the inside sur-
face of the fan light fixture rim.
Step 11. Carefully lift the glass shade
up inside the light fixture as far as it
will go.
Step 12. Rotate the glass shade in a
clockwise direction until it falls into the
notch for each tab.
Step 13. Turn power back ON at the
circuit breaker or fusebox.
This completes the installation of the
fan.
CANOPY
wASHER

BULB INSTALLATION

GLASS HOLDER
HALOGEN BULB

INSTALLING THE GLASS

NOTCH
FOR TAB
GLASS
S
tealth
HATCH
LOCk
CANOPY
SCREw
100 wATT MAX.
INDENTATION
®
CANOPY
TILT THE FAN TO
INSTALL LAST
CANOPY SCREw
TABS
MODEL AND
SERIAL NUM-
BER PLATE
FOR TAB
7